ALWAYS disconnect the power to the pump and drain all water from the system before servicing.Make certain the electrical power source is adequate for the requirements of the pump.Know the pump applications, limitations, and potential hazards.If the pump is plugged in, it may restart unexpectedly. Once the thermal protector detects that the pump has cooled to a safe temperature, it will allow the pump to operate normally.Overuse of this feature will damage the pump and void the warranty. For safety, the pump motor has an automatically resetting thermal protector that automatically will turn off the pump if it becomes too hot.The pump should be used with a 5/8″ (16 mm) or larger inside diameter garden hose, or use with a hose kit. Because this pump has an oil-filled motor, it should NOT be used in water containing fish. It is also not engineered to be run continuously as a “fountain” or “waterfall” pump. This pump is not designed to function as a permanently installed sump pump.To minimize the potential for water damage due to pump failure, please read the section of this manual regarding common pump problems and remedies or call 1-80. However, inadequate electrical power to the pump or blockage by ice, dirt, or debris may cause the pump to fail, potentially bringing about additional water damage. It will provide trouble-free service for many years when properly installed, maintained, and used. This pump is made of high-strength, corrosion-resistant materials.This pump has not been tested or approved for use in swimming pools or in salt-water marine areas. It can drain or remove water from the following: pits, sinks, window wells, basements, swimming pool covers, boats, low spots in yards, or other flooded areas. This submersible utility pump is designed for portable applications.This pump has NO repairable internal parts, and disassembling may cause an oil leak or dangerous electrical wiring issues Do not touch the pump housing while it is operating, as the pump may be HOT and can cause serious skin burns.Do not stand in water when the pump is connected.Always disconnect the pump from its power source before the inspection.Using this pump with or near flammable liquids can cause an explosion or fire, resulting in property damage, serious personal injury, and/or death. Do not use in the presence of flammable or explosive vapors. Do not pump flammable or explosive liquids such as oil, gasoline, kerosene, ethanol, etc.Running the pump without sufficient water will damage the pump and void the pump’s warranty. At water levels less than 1/4″ (6 mm), the pump is attempting to pump air, which will cause the pump to overheat and wear out. Always make sure the pump is unplugged as soon as the water level reaches 1/4″ (6 mm).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |